Risograph printing, or riso for short, is a way of printing that pushes ink through a stencil, one colour at a time. It sits somewhere between a photocopier and screen printing: as fast and cheap as the first, with the bright spot colours and handmade feel of the second.
How a risograph works
The Risograph is made by the Riso Kagaku Corporation in Japan and has been around since the 1980s. It was built as a duplicator for schools, offices and churches: a machine that could print hundreds of copies of one page for very little money.
Inside the machine your image is burned into a thin sheet called a master, as a pattern of tiny holes. The master is wrapped around a drum filled with ink. The drum spins, the paper passes underneath and the ink is pressed through the holes onto the page.
One drum holds one colour. For a second colour you swap the drum, make a new master and feed the same paper through the machine again. A three-colour print has been through the printer three times.
Why riso prints look the way they do
Almost everything people like about riso comes straight from that process.
- Spot colours. The ink is not mixed from cyan, magenta, yellow and black. Each colour is its own ink, which is why riso can print a fluorescent pink or a clear orange that an office printer can not. The riso ink colour chart shows the inks with their hex codes.
- Colours that mix. The ink is slightly see-through. Where two colours overlap you get a third one for free: blue over yellow gives green, blue over pink gives violet.
- Grain. The ink sits on uncoated paper and never forms a perfectly even layer. Large areas of colour come out a little speckled.
- Halftone dots. A lighter tint is printed as a pattern of small dots, and on a riso print you can see them.
- Misregistration. Because the paper goes through the machine once for every colour, the layers never line up exactly. A shift of a millimetre is normal.
Printers call that last one a flaw. Riso fans call it the point. No two prints from the same run are quite the same.
What riso is used for
Riso is popular with illustrators, small publishers and print studios. You see it most in zines, comics, posters, art prints, flyers, greeting cards and record sleeves. It is at its best for runs of roughly fifty to a few thousand copies in one to four colours. Below that a master is hardly worth making, above it offset printing becomes cheaper.
There are limits. Most machines print up to A3. Photos work, but they come out grainy and in whatever inks the studio has. The ink can smudge on coated paper, so riso is nearly always printed on uncoated stock. And because every colour is a separate pass, each extra colour adds cost.
Riso or screen printing?
The two are close relatives: both push ink through a stencil in separate colour layers. Screen printing is done by hand, works on fabric and almost any other material, and lays down a thick, opaque layer of ink. Riso is a machine, prints on paper only and is much faster, with thinner, more transparent ink. For a stack of two-colour posters or a zine, riso is usually the cheaper choice.
Try the look without a printer
You do not need a risograph to design in this style. Riso Lab recreates the marks above on screen: you layer shapes in riso ink colours, the inks mix where they overlap, and three sliders add grain, ink texture and misprint. The riso effect generator page explains what each slider does.
If you would rather build the effect yourself, read how to get a riso effect in Figma, Photoshop and Canva.
Last updated on 21 November 2026, by Michelle of Riso Lab.